2014 LPI 117-202 Dumps Free Download(31-40)

What file should be edited to make the route command show human-readable names for networks? (Please enter the full path)
Answer: /etc/networks

What is the command to add another IP address to an interface that already has (at least) one IP address?

A.    ifconfig eth0:1
B.    ifconfig eth0
C.    ipconfig eth0:1
D.    ipconfig eth0

Answer: A

route shows the following output:

Which of the following statements is correct?

A.    The network is not a valid route.
B.    The host is temporarily down.
C.    The host route is rejected by the kernel.
D.    The “!H” signals that traffic to the host is dropped.
E.    The network path to the host is not available.

Answer: C

A network client has an ethernet interface configured with an IP address in the subnet This subnet has a router, with the IP address, that connects this
subnet to the Internet. What needs to be done on the client to enable it to use the router as its default gateway?

A.    Run route add default gw eth1.
B.    Run route add gw eth1.
C.    Run ifconfig eth0 defaultroute
D.    Add “defaultroute” to /etc/resolv.conf.
E.    Run route add defaultgw= if=eth0.

Answer: A

A server with 2 network interfaces, eth0 and eth1, should act as a router. eth0 has the IP address in the subnet and eth1 has the IP address in the subnet The routing table looks fine, but no data is traversing the networks. Which TWO of the following need to be done?

A.    Enable IP forwarding with echo “1” > /proc/sys/net/ipv4/ip_forward
B.    Add new firewall chains to handle inbound & outbound traffic on both interfaces.
C.    Reconfigure the firewall rules to allow traffic to traverse the networks.
D.    The routing table needs to be restarted, for the changes to take effect.
E.    The server needs to be restarted, for the changes to take effect.

Answer: AC

What command is used to add a route to the network via

A.    route add – network netmask gw
B.    route add – net gw
C.    route add – network
D.    route add – net netmask
E.    route add – net netmask gw

Answer: E

Considering the following kernel IP routing table now, which of the following commands must be emove the route to the network


A.    route del
B.    route del
C.    route del -net
D.    route del gw
E.    route del -net

Answer: C

Which of the following sentences is true, when using the following /etc/pam.d/login file?
auth required /lib/security/pam_securetty.so
auth required /lib/security/pam_nologin.so
auth sufficient /lib/security/pam_unix.so shadow nullok md5 use_authtok
auth required /lib/security/pam_ldap.so use_first_pass
account sufficient /lib/security/pam_unix.so
account required /lib/security/pam_ldap.so
password required /lib/security/pam_cracklib.so
password sufficient /lib/security/pam_unix.so nullok use_authtok md5 shadow
password required /lib/security/pam_ldap.so use_first_pass
session optional /lib/security/pam_console.so
session sufficient /lib/security/pam_unix.so
session required /lib/security/pam_ldap.so

A.    All users will be authenticated against the LDAP directory
B.    This is the only file needed to configure LDAP authentication on Linux
C.    Only local users will be able to log in, when the file/etc/nologin exists
D.    Ordinary users will be able to change their password to be blank
E.    If the control flags for auth were changed to required, local users wouldn’t be able to log in

Answer: D

LDAP-based authentication against a newly-installed LDAP server does not work as expected. The file /etc/pam.d/login includes the following configuration parameters. Which of them is NOT correct?

A.    password required /lib/security/pam_ldap.so
B.    auth sufficient /lib/security/pam_ldap.so use_first_pass
C.    account sufficient /lib/security/pam_ldap.so
D.    password required /lib/security/pam_pwdb.so
E.    auth required /lib/security/pam_ldap.so

Answer: E

What is the advantage of using SASL authentication with OpenLDAP?

A.    It can prevent the transmission of plain text passwords over the network.
B.    It disables anonymous access to the LDAP server.
C.    It enables the use of Access Control Lists.
D.    It allows the use of LDAP to authenticate system users over the network.
E.    All of the above.

Answer: A

If you want to pass the LPI 117-202 Exam sucessfully, recommend to read latest LPI 117-202 Exam full version.


Lead2pass Testking Pass4sure Actualtests Others
$99.99 $124.99 $125.99 $189 $29.99-$49.99
Real Questions
Error Correction
Printable PDF
Premium VCE
VCE Simulator
One Time Purchase
Instant Download
Unlimited Install
100% Pass Guarantee
100% Money Back